Home > General > Windows/system32/config/system.problems.

Windows/system32/config/system.problems.

God Bless !!! im useing Windows Xp Home edition on a Dell Pc. SCRATCH THAT, IT FIXED ITSELF. I'm also having the same problem but my computer doesn't have CDROM Drive. his comment is here

To use this file, run the following command when you start in Recovery Console: batch regcopy2.txt Part Four 1. this is my problem too and it says I have to press "R" to repair but nothings happened.. Maybe there is still a recovery partition. It's and old satellite A80 that I'm repairing for someone to play on.

Members can monitor the statuses of their requests from their account pages. You can go to part four. You are doing something wrong with the burn process.

Reply Dan Jul 23, 2014 @ 14:20:58 Omg this is brilliant! Open Windows Explorer. Thank you so much for sharing. Nothing works.

It takes less than a minute and is completely free! then u want to type the word "help" that will give you a list of all the commands . If you run into this issue then you can do a manual registry repair kind of like doing XP system restore (only without windows working). you could check here Boot to Windows

After performing the copy and rename actions, take out the CDROM out from the CD DRIVE and reboot your computer.

Now, your computer should normally boot in Windows.

To use this file, run the following command when you start in Recovery Console: batch regcopy1.txt With the batch command in Recovery Console, you can process all the commands in a When this error occurs your computer will have the error message as shown below. I tried the procedure in this site, and while I was able to burn the procedure from another computer in to a CD I cannot continue on my problematic lap top. Choose the Last Known Good Configuration. 14.

Found you online and burned the disc and fixed everything. Burn a new one (in a lowest speed) and try again. 2. Replace your Hard Disk. so the HDD thing fin and i thought that windows was workin again but alas, it comes up with a big msg box with a the red cross thing (every1 loves

Get a discounted price on replacement setup and installation discs: Windows XP. http://ix2003.com/general/c-windows-inf-asynceqn-pnf.html Reply Nigel Hay Sep 10, 2014 @ 22:20:32 I had the dreaded “Windows XP could not start because the following file is missing or corrupt: \WINDOWS\SYSTEM32\CO A CCM membership gives you access to additional options. Bu tercihi aşağıdan değiştirebilirsiniz.

You must use these files to replace the registry files currently in the C:\Windows\System32\Config folder. Finally, if during the Windows installation you encounter errors it's likely that your hard disk drive is bad. Note This folder contains one or more _restore {GUID} folders such as "_restore{87BD3667-3246-476B-923F-F86E30B3E7F8}". http://ix2003.com/general/c-windows-system32-rdriv-sys.html Before you start this procedure, you must change several settings to make the folder visible: This is for preventing the damage of the system32.

Reply GoKuPOLAND Jan 31, 2014 @ 23:27:23 WIndows could not started due to an error while booting from a RAMDISK. Uz-Source iXacker 446.016 görüntüleme 1:23 el archivo system32 falta o esta dañado - Süre: 7:33. From the Accessories drop down menu click on System Restore.

You can change this preference below.

by John.Wilkinson / December 11, 2006 11:57 AM PST In reply to: Thanks In this case you don't want/need fixmbr. What should I do? When you finish this procedure, the system returns to a state very close to the state before the problem occurred. It is assumed that your root directory will be C: However, if your root directory isn't C:, for example, if you have other partitions/drives on your system you may have installed

At the Recovery Console command prompt, type the following lines, pressing ENTER after you type each line: md tmp copy c:\windows\system32\config\system c:\windows\tmp\system.bak copy c:\windows\system32\config\software c:\windows\tmp\software.bak copy c:\windows\system32\config\sam c:\windows\tmp\sam.bak copy c:\windows\system32\config\security c:\windows\tmp\security.bak Select "R" at the first screen to start repair The error message means the system boot files are missing are corrupted Quote: i hav no idea what this means or how This helped me a lot..

Reply

  • check over here When the "Hiren’s BootCD” menu appears on your screen, use your keyboard arrows keys to move into the “Mini Windows Xp” option and then press "ENTER" Step 4: Restore the corrupted

    John Barnett. Search Sign Up Log In Home Forum How To Download News Encyclopedia High-Tech Health Sign Up Language English Español Deutsch Français Italiano Português Nederlands Polski हिंदी Bahasa Indonesia Log In Subscribe